Este sitio web usa cookies para darte la mejor experiencia de navegación. Si desea aceptarlas, sólo tiene que hacer click en el botón 'Aceptar Cookies'. Si pulsa el botón 'Rechazar Cookies' será redirigido al apartado correspondiente de nuestra Política de Cookies donde tiene una explicación acerca de cómo evitar el uso de cookies en este sitio web, y ya no volverá a ver este aviso. Le informamos y ayudamos a administrar sus cookies en nuestra Política de Cookies.

Aceptar Cookies Rechazar Cookies

FICHA DE PRODUCTO

3.- DOBLE F6350. Amplificador de Tensión y Corriente

3.- DOBLE F6350. Amplificador de Tensión y Corriente

REAL TIME POWER SYSTEM SIMULATION INTERFACE

You can now convert your F6150 to a set of voltage and current amplifiers whenever there is a need for such an application. In this mode of operation, the F6150 converts to a set of voltage and current ampliers. These amplifiers can be controlled by RTDS®. Hence low level signals from the RTDS® are fed to the F6350 via a special Doble furnished cables. The output of the F6350 is amplified signals that are supplied to the relays or protection schemes under test. You can use multiple F6350 and get as many voltage and current signals you require for complete testing of relays and protection schemes.

If you only need additional current channels, you can use F6300 instead of a second F6350 to get the required number of current channels.

The conversion of F6150 to F6350 is very simple. It requires a simple replacement of a single I/O card and installation of the firmware.

Converting the F6350 back to F6150 is also simple. Simply replace the original I/O card and load the firmware needed for F6150. This will convert your F6350 back into an F6150.
 

VOLVER ...

MEGACAL. Calibracion, Potencia y Energia. Mantenimiento Electrico.

Calle Foronda, 4 - Planta 4ª - 28034 - Madrid.

91 571 00 24   /   91 571 23 46